57
INOVANCE TECHNOLOGY EUROPE GmbH
MD800 EtherCAT Starting Guide_EN_v1.1_20211109.docx
Switch between operation panels.
2: Forward and reverse switching
Switch the direction of frequency
command by MF.K key. This
function is only available when
the command source is running.
It is valid when the command is
the operation panel.
3: Forward jog
Realize forward jog (FJOG) by
MF.K key. This function is only
available in the command source
It is valid when the line command
is the operation panel.
4: Reverse jog
Reverse jog (RJOG) is realized by
MF.K key. This function only runs
at the command source
It is valid when the command is
an operation panel.
F7-02
STOP key function
0
0: Only in keyboard
operation mode:
STOP/RES
1: In any operation
mode, the STOP/RES
key stops
The STOP button on the operation
panel is the stop/reset button, set
STOP behavior by this parameter
The function of the key.
0: Only in the keyboard operation
mode, the stop function of the
STOP key is valid
Only in the keyboard operation
mode, the stop reset function of
the STOP key is valid.
1: In any operation mode, the
stop function of the STOP key is
valid
In any operation mode, the stop
reset function of the STOP key is
valid.
F7-03
Display
parameter 1
31
BIT00: Operating
frequency (Hz)
BIT01: Setting
frequency (Hz)
BIT02: Bus voltage (V)
BIT03: Output voltage
(V)
BIT04: Output current
(A)
BIT05: output power
(kW)
BIT06: Output torque
(%)
BIT07: DI input status
BIT08: DO output
status
BIT09: AI1 voltage (V)
BIT10: AI2 voltage (V)
If you need to display the
following parameters during
operation, set their corresponding
positions to 1. Set this binary
number to hexadecimal and set it
in F7-03.
Pressing the shift key
the
configured parameters can be
displayed