3.1. WARNING SYMBOLS
3. Safety
Safety hazard for people in general and/or equipment
ATTENTION
Important instruction to prevent damage to the equipment and/or its function
3.2. GENERAL SAFETY INSTRUCTIONS
Read the instruction manual carefully before installing and starting the valve. Contact
INOXPA in case of doubt.
3.2.1. During installation
Always take into account the
Technical Specifications of chapter 9
.
The installation and use of the valve should always be in accordance with applicable
regulations regarding health and safety.
Before starting up the valve, check that it is assembled correctly and its shaft is perfectly
aligned. Incorrect alignment and/or excessive stress during coupling can cause serious
mechanical problems in the valve.
3.2.2. During operation
Always take into account the
Technical Specifications of chapter 9
.
NEVER exceed the specified limit values.
NEVER touch the valve and/or piping that is in contact with the fluid during operation. If
the process involves hot products there is a risk of burns.
The valve contains parts that move in a linear fashion. Do not place hands or fingers in
the valve closing area. This can cause serious injury.
3.2.3. During maintenance
Always take into account the
Technical Specifications of chapter 9
.
NEVER disassemble or remove the valve until the pipes have been emptied. Bear in
mind that the fluid in the pipe may be hazardous or extremely hot. Consult the regula
-
tions in effect in each country for these cases.
Inside the actuator there is a spring with an applied load. The steps specified in this ma
-
nual must be followed when performing maintenance operations to avoid injury.
Do not leave loose parts on the floor.
Safety
INOXPA S.A.U.
10.260.30.01EN · (A) 2022/09
6