Insane Audio’s JK1001 is pre-wired to automatically work with
a reverse camera and your camera should automatically
display when the vehicle is in reverse.
Once everything is properly connected, if you place your
vehicle in reverse and you see a “No Signal” warning, then
that means that you aren’t getting a clear signal to the CAM IN
port. Be sure to double-check that your power and video
connections are solid.
If everything is properly connected and you are still unable to
see images from the camera when in reverse, be sure that the
CAMERA wire on your JK1001 is properly connected.
The IACAM2 comes with an 18.5mm hole saw bit for a power drill.
This bit can be used to flush-mount your IACAM2 in to your vehicle.
To do this:
1. Ensure the area you want to install your camera has been
tested for viewing angles on your JK1001.
2. Be sure that there are no wires or hoses in the area that the
hole will be drilled.
3. Mark the center of your hole to be drilled.
4. After installing the hole saw properly in to a power drill,
place the protruding drill bit on to the center you just
marked.
5. Drill through the area you want, making sure the hole saw
goes all the way through the area you are drilling.
6. Unscrew the mounting collar from the front of the camera.
7. Place the camera and metal tension collar in the hole, from
the back, so that the lens is facing the desired direction.
8. Screw the mounting collar on to the camera from the front
of the hole.
9. Verify that your viewing angles are still correct and make
any needed adjustments, then tighten mounting collar on
camera completely.
