BCI Mfg Inc P.O. Box 1207 North Plains, OR 97133 info@insideride.com
Core E-flex Assembly
Starting with the forward
connection, guide the
connector into position so
the two threaded studs fit
into the holes in the Core
leg. Then insert the rear
connector so its two
threaded studs fit into the
holes. The connectors are rubber mounted, so you can easily flex them into
position. Once you have both connectors installed, put the wing nuts on and
tighten by hand.
Now set the entire assembly upright. The Core
should be sitting approximately vertical on the
base. It should be free to rock side to side and
move forward and back smoothly.
This is the finished rear assembly ready to be attached to the bike. Install the
bike as you normally would, leaving front wheel on for now. Do not fully
tighten the bike’s rear axle until the fork stand is attached.
After
Rear Connector
