insigniarange.com
Last Modified:13/06/2017
15
Step 8
Now apply
silicone
to the bottom of the remaining curved rail and place into position as
shown in the diagram and fix this into place using the
ST35
screws and
ST25
screws
Please note that when drilling the holes to take the screws this is at a depth no deeper than
5mm.
Step 9
Apply
silicone
to specified area as shown on the diagram, then take the front curved glass
panel and insert into the upright. Then using the flat rubber seal insert in between the glass and
upright.
NOTE:
(It’s common that the curved glass once is position may not fit completely snug against the rail
due to alignment. This is normal and is rectified by the use of a silicone seal)