insigniarange.com
Last Modified:13/06/2017
16
Step 10
Insert remaining upright to the left of the curved glass panel. Drill and screw this
into position using the
ST20
screws
and once fixed slide the flat rubber glass seal into
this newly fitted upright on the inside (as of the green line in the image)
Please Note
: ensure you drill no deeper than 5mm.
Step 11
Pierce through the holes using a screwdriver to show pre
-
cut holes in the glass as
indicated in the image. Now using the chrome “L” brackets, fix these to the outside of the
glass panels using the provided nuts and bolts (
B22
) please ensure the bolt goes
through the plastic cover holder (
PCH13)
first
Align the shower panels until you are happy with the sitting of these and now using the
ST25
screws, screw the brackets to the tub
Now place the Chrome cover caps (
CPC16
) onto the cover holders (
PCH13
)
Back
Inside
