Note
Write protection setting methods: enter into ALL-100 upgrading interface “
AUTO
”, tick off
option “
Config
”, click item “
config Setting
”, set option “
Protect
” as “
All Protect
” and
“
SRWD
” as “
Enable
”, then press “
OK
” to complete write protection setting;
Please make sure option “
Config
” is ticked off during software upgrading process and reset
write protection after ALL-100 upgrading software is opened each time;
8
HDCP KEY upgrading processes
(1) Connect with upgrading jig;
(2) Operate
ISP_ToolV1.04.exe
shown as Fig. 2:
Fig. 2 ISP tool
(3) Click button ‘
open
’ to load encrypted
KEY
file;
(4) Click button ‘
Run
’ to perform
KEY
upgrading, upgrading information will be listed within
information frame after upgrading completed.
9 EEPROM initialization (Only used if necessary)
Detailed procedures: Press key
IR POWER/KEYPAD POWER
to turn on the TV set, keep
pressing key
INPUT SOURCE
on the panel before
SHOW LOGO
until indicator light on the panel
turns into red, then press keys
MENU, VOL+, CH+
in turn at 2S interval, indicator light on the panel
turns into blue and the TV set turns into
STANDBY
mode after a while, now
RESET EEPROM
succeeds; if key order or key value is wrong, or no key is pressed within 2S interval, previous setting
will keep on being performed and EEPROM will not be cleared out as well.
Address: 0x1B0000
Information frame
Aligment Instructions
