Adjustment Instructions
1
Safety Instructions
1.1 Power supply must be cut off when replacing or welding any component or inserting / pulling out
connective lines;
1.2 Anti-electrostatic measures must be carried out during the whole producing processes!
a) Do not touch IC by hands at will;
b) Use anti-electrostatic iron;
c) Welder must wear anti-electrostatic glove;
1.3 Replacing any component with special safety requirement must refer to component list without
changing its specification and model at will.
1.4 Power supply voltage must be
120 V±10%
, or 220 V would burn out power board.
2
Adjustment Equipments
VG-848 (YPbPr, VGA signal generator)
DVD (HDMI signal generator)
CA-210
3
Adjustment Processes
3.1 Power voltage test
According to the wiring diagram ‘92XXMF7001JL’ or ‘92XXMF7501JL’, connect power board
assembly, data processing assembly, IR/Key board assembly, backlight board assembly correctly,
supply with power, press button
standby
to power on the TV set.
3.1.1 Model LC-37/39/42/46MFXX
a) Test voltage of X504 each pin on power board in turn shown as Table 1:
Table 1 Voltage of X504 each pin
X504
Pin 1
、
2 3
、
4 5
、
6 7
、
8
9 10 11 12 13
Min. (V)
11.3
0
11.3
0 2.85
4.85
4.85 3.25 4.85
Typical(V) 12.0
0
12.0
0 3.00
5.00
5.00 3.30 5.00
Max.
(V)
12.6 0 12.6 0 3.15 5.35 5.35 3.30 5.35
b) Test voltage of X505 each pin on power board in turn shown as Table 2:
Table 2 Voltage of X505 each pin
X505 Pin
1 2 3
~
7 8
~
12
Min.
(V)
3.25
4.85 0 23.8
Typical(V) 3.30
5.0
0
24.0
Max.
(V)
3.30
5.35 0 25.2
Aligment Instructions