5
Insignia NS-LTDVD19 19" LCD TV/DVD Combo
www.insignia-products.com
Setting up your LCD TV/DVD
combo
Installing remote control batteries
To install remote control batteries:
1
Remove the battery compartment cover.
2
Insert two AA batteries into the battery
compartment. Make sure that you align the +
and – symbols on the batteries with the + and
– symbols inside the battery compartment.
3
Replace the battery compartment cover.
Connecting an antenna
To connect an antenna:
1
Make sure that your LCD TV/DVD combo is
turned off.
2
Plug one end of a 75 ohm cable (not
included) into the
ANT IN
jack on the back of
your LCD TV/DVD combo.
3
Plug the other end of the cable into the
outside antenna jack.
Connecting cable or satellite TV
To watch cable or satellite TV, you need a TV
tuner device or a cable or satellite TV converter
box.
There are two ways to connect cable or satellite
TV to your LCD TV/DVD combo.
Option 1
To connect cable or satellite TV:
1
Make sure that your LCD TV/DVD combo
and converter box are turned off.
2
Connect a 75 ohm cable (not included) to the
RF
jack on the cable or satellite TV converter
box and to the
ANT IN
jack on the back of
your TV.
3
Connect one end of a 75 ohm cable (not
included) to the cable jack on the cable or
satellite TV converter box and to the cable or
satellite TV wall jack.
4
Set the channel switch on the cable or
satellite TV converter box to 3 or 4.
5
Turn on your LCD TV/DVD combo and the
converter box, then tune your LCD TV/DVD
combo to the same channel you set the
channel switch to.
6
Use the cable or satellite TV remote control
to tune channels.
Option 2
To connect cable or satellite TV:
1
Make sure that your LCD TV/DVD combo
and cable or satellite converter box are
turned off.
2
Connect audio and video out jacks on the
cable or satellite TV converter box to the
AUDIO IN
and
VIDEO IN
jacks on the back of
your TV.
3
Turn on your LCD TV/DVD combo and the
converter box, then press
INPUT
to select
TV
.
Notes
Make sure that there is no obstruction between
the remote control and the remote sensor on your
LCD TV/DVD combo.
Keep the remote control away from heat sources
or humid areas.
Strong light may affect the signal between the
remote control and the remote sensor on your
LCD TV/DVD combo. If the remote control does
not work, change the position of the remote
control.
Make sure that the batteries are alkaline batteries.
Batteries must be of the same type.
Do not mix old and new batteries.
Do not use rechargeable batteries.
Caution
Do not bend the bronze wires on the cables.
Notes
To improve picture quality in an area with poor
signal reception, install a signal amplifier.
If you want to connect two TVs to the antenna,
install a 2-way signal splitter.
Caution
Do not bend the bronze wires on the cables.
Summary of Contents for NS-LTDVD19 - 19" LCD TV
