13
17 or 21 Cu. Ft. Upright Convertible Freezer/Refrigerator
www.insigniaproducts.com
• The freezer storage shelves should not be lined with aluminum foil, wax paper,
or paper toweling. Liners interfere with cold air circulation, making the freezer
less efficient.
• Organize and label food to reduce door openings and extended searches.
Remove as many items as needed at one time, and close the door as soon as
possible.
Understanding Alerts
High Temp Alert
The freezer is having trouble maintaining a cold temperature. You will get this
alert if:
• FREEZER MODE: the inside temperature is over 18° F (-8° C) for 36 hours.
• FRIDGE MODE: If the inside temperature is over 59° F (15° C) for 36 hours.
The LED on control panel turns on and a beep sounds. If the temperature returns
to a normal range, the alert turns off. You can also press any button to turn it off.
Here are some possible causes:
• The room is too warm. For example, the freezer is in a garage in the summer
next to a car with a hot engine.
• The ventilation openings are blocked or dusty.
• There is too much frost build up.
• There are door seal gaps.
Door Open Alert
If the door is open for more than five minutes, the door open alert is activated a
buzzer sounds intermittently. Close the door to turn off the alert and check to
make sure that nothing is blocking the door, preventing it from closing. Also,
check to make sure that the freezer is level. An unlevel freezer may prevent the
door from closing properly.
How do I reset my freezer to factory defaults?
1
Press and hold Lock for three seconds to unlock the control panel.
2
Press the
Lock
and
+
buttons at the same time for three seconds to reset the
freezer to factory defaults. The panel beeps and all of the indicators turn on for
three seconds. If the compressor is running, it pauses for five minutes, then
restarts.
Troubleshooting
Fault indication
If a fault is detected, the display shows one of the following codes. If a fault is
indicated, call for service:
CAUTION
: Do not try to repair your freezer yourself. Doing so invalidates the warranty.
Fault code
E2
E5
E7
Description
Temperature sensor fault
Defrost sensor fault
Ambient Temperature sensor fault
