10
NS-WB44SS8
www.insigniaproducts.com
Reversing the door
You will need a 10 mm socket wrench and a Phillips screw driver. Have
someone available to assist you in the process.
•
Keep all of the parts you remove to reuse them later.
•
Removing the door requires that the cooler be tilted backwards.
1
Make sure that your wine cooler is unplugged and empty.
2
Adjust the two leveling feet to their highest position.
3
Remove the screw that holds the top hinge cover on your cooler, then
remove the top hinge cover.
4
Remove the screws holding the top hinge of your cooler, then remove
the hinge.
5
Remove the screw hole covers from the top left side of the cabinet.
6
Pull the door upwards and remove it from the lower hinge.
7
Remove right door stopper and hinge pin sleeve. The right door
stopper should be kept if the door hinge needs to be moved to the
right side again.
8
Remove the screws for the toe kits, then remove the toe kit.
9
Remove the screw holding the bottom hinge on the right side, then
remove the hinge. Reinstall the screw into the right hinge hole of the
cabinet.
Caution
Do not lay the wine cooler completely flat as that could damage
the coolant system.
Screw hole
covers
Hinge cover screw
Hinge cover
Hinge screws
Hinge
Right door
stopper
Hinge pin sleeve
Screws
Lower hinge
Screws (2)
Toe kit
Screws (2)
NS-WB44SS8_17-0586_MAN_V1_ENG.fm Page 10 Monday, August 14, 2017 8:44 AM
