16
www.insigniaproducts.com
Troubleshooting
Error codes
If a fault is detected, the display shows one of the following codes:
•
E1:
Temperature sensor fault
•
E6
: Communication fault
If any of these error codes appears on the display, contact your local dealer or
service center. Do not try to repair your cooler yourself.
PROBLEM
POSSIBLE CAUSE
SOLUTION
My cooler does
not operate.
Your beverage cooler
is unplugged.
Make sure that your cooler is plugged in
and that the plug is pushed completely into
the outlet.
The fuse on the circuit
is blown or the circuit
breaker is tripped.
Check the house fuse or circuit breaker box
and replace the fuse or reset the circuit
breaker.
Power failure.
If a power failure occurs, your cooler turns
off. Wait until the power is restored, then
turn it on again.
The plug does not fit
the outlet.
Make sure that your power source has the
correct voltage.
The cooler door
does not close
completely.
The shelf is out of
position.
Adjust the shelf correctly.
The door gaskets are
dirty.
Clean the door gaskets.
The cooler is not level. Level your cooler with the leveling feet.
The gasket has
deformed or does not
fit the shape of the
door.
If the door gasket does not seal, try heating
then cooling the seal. You can use an
electric hair dryer to heat the seal.
My cooler is not
cold enough.
The door has been
opened too often or
was not closed
correctly.
Make sure that the door is closed correctly.
You have just added a
large number of
warm beverages to
your cooler.
Allow time for new beverages to cool, then
check again.
The temperature
control is set too
warm.
Set the control to a colder setting.
Your wine cooler does
not have enough
ventilation.
Your wine cooler may not have enough
clearance from walls or the ceiling. See
Providing ventilation on page 8.
