7
29-Bottle Wine Cooler
www.insigniaproducts.com
Finding a suitable location
• Your cooler is designed to be free standing only, and it should not be recessed
or built into a countertop or wall.
• Place your cooler on a floor, counter top, or cabinet that is strong enough to
support your cooler when it is fully loaded.
• Allow 1.6 in. (4 cm) of space on all sides of your cooler to allow for correct air
ventilation.
• Place your cooler away from direct sunlight and sources of heat (such as a
stove, heater, or radiator). Direct sunlight may affect the acrylic coating and
heat sources may increase electrical consumption. Ambient temperature
below 50° F (10° C) or above 85° F (29.4° C) hinders the performance of your
cooler. Your cooler is not designed for use in a garage or any other outside
location.
• Avoid placing your cooler in moist areas.
• Your cooler is not designed to be installed in an RV or used with an inverter.
• Do not stack your cooler.
• For your cooler to operate normally, avoid placing it in areas with high
magnetic fields or high humidity.
Leveling your cooler
• Your cooler must be level in order to function correctly. If your cooler is not
leveled during installation, the door may not close or seal correctly, causing
cooling, frost, or moisture problems.
• To level your cooler, you may turn either leveling foot clockwise to raise that
side of your cooler or turn it counter-clockwise to lower that side.
Reversing the door
You need a 10 mm socket wrench and a Phillips screwdriver. Have someone
available to assist you in the process. Make sure that you keep all of the parts you
remove to reuse them later.
CAUTION:
Do not lay your cooler completely flat as that could damage the
coolant system.
18.9 in.
(48.0 cm)
33.1 in. (84.2 cm)
17.3 in. (44.0 cm)
29.9 in. (76.0 cm)
