7
n
Identify locations for the faucet and tank.
n
Check to make sure counter is not too thick.
n
Make sure there is a GFCI outlet under the sink.
The wall outlet for your faucet must have power
supplied to it continuously and must be fused.
n
If drilling a hole into a stainless steel sink or counter
top, you can cut a mounting hole for the faucet with
a hole saw for stainless steel, or you can use a hole
punch.
Consult a professional before drilling into
a surface other than stainless steel.
Required minimum from center of hole to wall
Maximum counter thickness (depth)
2" (51 mm)
5
/
8
" (16 mm)
A
Required hole size (diameter)
1"– 1½" (25 – 38 mm)
These instructions are separated into main sections,
indicated by numbers, and subsections, indicated by
capital letters. The manual is setup this way to allow you
to take a break at any point after completing a section or
subsection without affecting the installation process.
How To Use This Instruction Manual
Provides a step-by-step narrative describing
the installation step, with tick boxes that can be
marked as you progress through the installation.
Contains simple illustrations that provide visual
instruction to support the narrative.
WARNINGS, CAUTIONS and NOTICES that will
require your attention during the step.
1
2
3
ELECTRIC SHOCK HAZARD
Appliance must be grounded.
1. PREPARATION
Proper installation should take 2-4 hours.
Installation
A
Turn off water supply.
B
or splash mount configuration.
Decide on deck mount...
B
C
