11
Operating Instructions
MAIN OPERATION (cont.)
Place scrap basket inside waste collector tank. Unit
must always have the scrap basket in place during
operation.
Place cover on waste collector tray. Use of cover is
optional but recommended to maximize workspace.
NOTE:
When using the Pot/Pan tray (Model PRP), the
cover fits in the square, flat area at the bottom of the tray.
To begin, press START button on control and allow the
reservoir tank to fill with water. Indicator light turns on.
Pump turns on and water plume starts once tank has
reached optimal fill level (approximately 70 seconds
after pushing the START button).
Adjust ball valve until water plume hits desired location
inside tray area (recommended location is the center of
scrap basket and/or cover).
Scrap soiled dishes using the water plume
to help move solid waste from the surface.
Pre-soak problem dishes with baked-on or difficult to
remove food by setting them on the cover under the
plume. Solid waste is collected in the scrap basket.
Press STOP on the control panel. Indicator light turns off.
Scrap
Basket
Waste
Collector
Tank
3
Cover
Waste
Collector
Tray
4
Start
Indicator Light
5
Ball
Valve
Water
Plume
6
Stop
8
Indicator Light
DO NOT
use corrosive chemicals for scrapping.
