4
Product Overview
SYSTEM COMPONENTS
The PowerRinse
®
Waste Collection System includes the
following components (see Figure 3):
a. Tray
• Standard Tray (Only Model PRS)
OR
• Pot/Pan Tray (Only Model PRP)
b. Scrap Basket
c. Cover
d. Plume Hose
e. Waste Collector Base Assembly (see Figure 4)
f. Waste Collector Tank and Mounting Assembly
g. Control (Pre-wired)
h. Solenoid (Pre-wired)
i. Pump (Pre-wired)
j. Air Gap
k. Ball Valve
l. Leveling Flange Feet
m. 2" Drain Discharge
n. 1/2" NPT Water Inlets (Hot and Cold Connections)
o. Installation, Care, and Use Manual
p. Mounting Hardware
• Lock Washers (12)
• 1/4"-20 Nuts (12)
TYPICAL INSTALLATION
Figure 4 illustrates the typical installation of the
PowerRinse
®
Waste Collection System. For a
complete list of system components refer to the
System Components list located to the left of Figure 4.
See Figure 5 on next page for system dimensions.
REQUIRED TOOLS / MATERIALS
The following items are needed to install the PowerRinse
®
Waste Collection System:
o
Screwdriver
o
Pipe wrench
o
7/16" wrench or socket
o
Tools and materials necessary to install the power line,
drain line, and the hot and cold water
The following items are needed if repositioning the control:
o
1/2" wrench or socket
Part No. 15392 Rev A
www.insinkerator.com/foodservice
Please be certain that the person who installs or uses this appliance carefully reads
and understands the Safety Instructions contained in this manual.
NOTICE is used to address practices not related to physical injury.
CAUTION indicates a hazardous situation which, if not avoided, could result in
minor or moderate injury.
WARNING indicates a hazardous situation which, if not avoided, could result in
death or serious injury.
Model PRS
Model PRP
OR
a
b
d
p
e
o
c
a
Figure 3. System Components
24" min.
(609.6 mm)
Dish Rack Space
Dishwasher
Incoming
Power
(1/2" Conduit)
Min. 1"
Clearance
Incoming Hot
and Cold Water
Supply Lines
i
h
g
f
l
m
j
k
n
Figure 4. Typical Installation
The PowerRinse
®
Waste Collection System pump
motor fan must have a minimum of 1" of clearance
from any wall or obstruction in order to operate
correctly.
