Insnrg Qi 1100, Installation & Operating Manual

21

22

FUNCTION

The Function Button is used to move between different menus 
in the Pump Operation.  In order, they are as follows:

Function 1 

– Clock Setting

Function 2 

– Timer Setting

Function 3

 – Priming Setting

Function 4

 – External Temperature Setting (Freeze Protection)

Function 5

 – Anti Freeze Setting

Function 6

 – Power Cost Setting

Function 7

 – Pump ID Setting

Press the Function Button to move your way down the list of 
Numbers on the Left Hand Side until you reach the Setting 
area you require.

Function 1 - Clock Setting

Press function button until F1 is selected to display Timeclock:   
Scroll left or right to select hour/minute, press up or down 
to change hour or minute.  Clock setting is 24 hour format 
(ie 08:00 for 8am and 20:00 for 8pm).  Once happy with time 
setting either scroll left or right off the hour or minute, or press 
the function button and the new hour or minute setting will be 
stored.

FUNCTION 2 – TIMER SETTING

Press function button until F2 is selected to move to Timer 
Menu.  Screen will allow you to select Active or Inactive by 
pressing the Left or Right button.  If “Timers Inactive” selected, 
display “Timers Inactive”.   

If “Timers Active” selected, screen will then displays timer 1 (T1) 
to Timer 4 (T4) above 4 horizontal buttons beneath LCD screen 
and a summary of timer periods as below.

Insnrg will send the Variable Speed Pump factory programmed 
with start time of 08:00 and stop 12:00 for Timer 1, then 18:00 
start and 20:00 stop for Timer 2.  If you are happy with this, you 
can leave as factory settings.  To change the timer settings, 
select the Timer Period you wash to adjust by pressing the 
corresponding button below the screen.  Similar to the Clock