Insnrg Qi 1100, Installation & Operating Manual

23

24

Setting, move around the time period by Scroll Left and Right, 
then adjust with Up and Down.  Continue to scroll right to select 
speed of pump for that time period.  Press up or down to select 
speed 2, 3, or 4.

Press buttons underneath T1, T2, T3, T4 to select timer period.  
Continue to repeat timer programming by selecting each period 
as you desire.

Should you wish to turn off a Timer period, you can scroll to 
right and select “Pump Off”.  This could be a useful feature for 
Summer and Winter periods where you want to operate the 
pump less in Winter.

Please note: Timer periods can’t overlap.  If next timer is due 
to start before previous timer period finishes, then message on 
screen will state that “Timers cannot overlap”.

Once your happy with your Timer settings either Press the 
Function button to adjust another menu, or press the On/Off/
Auto button to save settings and operate your pump.

FUNCTION 3 – PRIME SETTING

Press Function Button until F3 is selected to move to Prime 
Menu.

There are two choices using the Left or Right buttons.  
Selecting Prime Time or Auto Prime.  Prime Time allows you to 
set the preferred starting speed for your pump and how long 
you wish this to run.  The Speed and Time will be dependant 
on how your pool has been set-up by your pool professional.  
In most instances, the priming speed will operate near high 
speed for a period of 5 minutes to ensure the pump is primed 
and the water is circulating after being turned off for a period 
of time.  However, you can also use the Prime Time to operate 
Suction Cleaners, Heaters or other equipment that may require 
extra flow for a designated period of time.

If you select “Prime-Time” the below screen will display and 
prompt you to adjust the Period Time and RPM Speed using 
the scroll left or right buttons, then up and down buttons 
similar to other operations.