Page 6
ATTACHING THE CABLE:
1.
There are two CABLE ENDS that need to be
attached to the ARMS. Install each CABLE END
to it corresponding arm using a (M10, 50MM,
Button Head Bolt), two (M10, Hat Washers) and a
(M10, Nyloc Nut) as shown. Tighten using a 6mm
hex key socket and a 17mm open end wrench.
INSTALLING THE SEAT:
1.
Align and install the ADJUSTABLE SEAT using
four (M8,16MM,Socket Head Bolts) and four
(M8,Washers) Tighten using a 6MM hex key.
Operate the seat up and down by squeezing the
red handle, the ADJUSTABLE SEAT should
operate smoothly.
GUIDE ROD LUBRICATION:
1.
Use a general purpose LUBRICANT that does not
contain Teflon or solvent (such as 3-IN-ONE® oil.)
Apply the LUBRICANT to a cotton cloth, then run
the cotton cloth up and down the guide rods as
needed to apply a thin coat.
2.
Also apply oil to the incremental weight guide
tracks.
3.
Verify that the top plate and incremental plate
slide smoothly.
Incremental
Guide Track
Guide Rod
Summary of Contents for IP-S4305
Page 1: ...SHOULDER PRESS IP S4305 INSTALLATION INSTRUCTIONS...
Page 9: ...Page 9...
