8
1. With the legs in the open and locked
positions, place the transfer base into
the shower or tub (Fig 13). Then, roll the
seating to the end of the tub base (Fig 14).
Note: The shuttle base is reversible and
can be installed on the slide rails in either
direction to accommodate any bathroom
layout.
2. Adjust the leg height of the tub base so
the frame tubes are at the same height as
the rolling base and both are aligned when
positioned end to end (Fig. 15).
3. Make rough adjustments (¾”) with the
detent buttons (Fig. 15), or make fine
adjustments by loosening the back knobs
(refer back to Fig. 12) and turning the legs
to the desired height. Tighten the adjusting
knobs when the height is set.
4. When the heights of the tub base and the
rolling base are equal, move the rolling base
as close as possible to the tub base. Place
the tongue of the manual locking latch over
the receiver on the tub base (Fig. 16).
5. Lock the rolling base to the tub base
with the center latch before attempting
to transfer or slide the rolling base. Loop
the tongue from the tub base over the
hook receiver on the rolling base. Lock
the base to the seating by pulling down on
the manual locking handle until the safety
lock clicks in place (Fig. 17). The safety
lock prevents the seating base from rolling
away.
Figure 13
Figure 14
Figure 16
Tongue
Figure 17
Locking latch
Figure 15
detent button
fine-tuning
knob
OPERATING THE TRANSFER SYSTEM
