14
METER INSTRUCTIONS
POWER UP
Connect all the cables to the monitor.
After powering up, all LCD segments will light up for 2 seconds and CPU will be reset the
resistance to level 1. The monitor will enter the initial mode.
If the connection cables are installed incorrectly, the motor will not work. Before contacting
service: Check the cable connection and then reset the power to release a beep sound or
press START/STOP key. Hold it to reset the device and to restart the system. If the motor still
doesn’t work, contact authorized service.
KEY FUNCTION
START/STOP
To start or pause the workout.
FUN/SCAN
Under stop condition, push it to enter parameter setting.
Confirm set values of the parameters and go into next setting.
In the start state, push it to display fixed current parameter values.
Push it to switch into automatic scanning function and parameter
displaying.
In parameter setting, push it to increase the value.
In start state, push it to increase the resistance.
In parameter setting, push it to decrease the value.
In start state, push it to decrease the resistance.
PROG/RESET
In stop state, push it to select required movement patterns.
In any state push it long (for 5 seconds) and the electronic watch
resets. All the data, except ODO will be reset.
Key combination: FUN/SCAN and simultaneously UP (+) button for 3 seconds
– motor
introspection.
Key combination: at the same time PROGRAM and DOWN (-) button for 3 seconds
– ODO
values examination.
