8
STEP 8
Install the bottle holder (27). To do it, loosen screw M4.2x16 mm (67) on the right cover (18).
Push the bottle holder (27) into the gap of the left and right covers (17 and 18) and tighten the
screw M4.2x16 mm (67) again.
STEP 9
Insert pedal shaft (6) through the tube that is located on the base frame (3). Slide pedal cap
(19) onto each end of the pedal shaft (6). Secure the pedal caps (19) using button head bolts
M8x15 mm (60) and large washers M8 (83) at both ends of the pedal shaft (6). You need to
use two Allen wrenches to tighten the button head bolts M8x15 mm (60) at both ends of the
pedal shaft (6) at the same time.
STEP 10
Insert the adaptor (94) into the hole of the DC power cable (96).
