10
OPERATIONAL INSTRUCTIONS
LOAD ADJUSTMENT
The resistance of the shock can be adjusted by turning the adjustment knob at the top of the shock.
There are setting from 1 to 12. 1 is lowest resistance 12 is highest resistance.
WARNING:
The shock gets
HOT
after few minutes of use.
PEDAL STRAP ADJUSTMENT
You can change the position of pedal strap (35) to the upper position in the pedal (34) as shown in the
picture. Get the pedal strap (35) through the opening from the bottom of the pedal (34) and then put
the pedal strap (35) through steel ring. Slide the steel ring down against the pedal (34). Get the pedal
strap (35) through the opening in the pedal (34) on the other side from the top as shown in the picture,
then make the end of the pedal strap (35) to go up and attach the end of the pedal strap (35) with
hook and loop strap to adjust length.
