Assembly Instructions
Step 1:attach the console masts to the base frame.
A;)put the console wire through the console mast .
B:)then attach left/right console mast into main frame with six M8X15mm bolt using washer wrench.
Step 2: attach the console crossbar to the console mast
A)
assemble the console crossbar to the console mast with four M8x20mm bolts and washer each side.
Step 3: attach the console to the console mast
•
connect the wire from the console to the wire in the right console mast.
•
assemble the console to the console mast with two M4x15mm bolts and wrench.(do not tighten the bolts)
ATTENTION: be careful when you connect the two console—controller wires,There are pins inside connector,
the pins must be straight, otherwise it will cause problems.
(Insure pins are straight)
Step 4: tighten step 1, step 2 ,step 3 bolts.
First open switch and working machine, then tighten bolts.
Instruction use
TURNING ON THE TREADMILL:
Make sure that the treadmill is correctly connected to power source. Open on/off switch (1), turn it ON and it
will be light. You will hear a signal tone and the LED screen of the Computer will light up.
Console mast
Console
Console mast
Console crossbar
