ADJUSTMENTS
Adjusting the Tension Control Knob
To increase the load, turn the Tension Control Knob in a clockwise direction.
To decrease the load, turn the Tension Control Knob in a counterclockwise direction.
Adjusting the Incline Adjuster
There are 3 incline angles that the incline adjuster can be set to. Loosen the Locking Knob by turning
counterclockwise direction. Place one hand on the rear end of the Main Frame, then lift the rear end of the Main
Frame up and use the other hand to remove the Locking Pins. Adjust the Incline Adjuster to the desired position
and insert the Locking Pins into the holes on the Main Frame and Incline Adjuster to lock the Incline Adjuster in
place. For added safety, tighten the Locking Knob in a clockwise direction.
Adjusting the Running Belt
The running belt is initially set and adjusted at the factory. However it may come loose during transportation
and/or during use. It is recommended that the user run on the center of the running belt. After prolonged use,
the belt will begin to stretch out. It is suggested that the user always to walk or run on the central area. This will
prevent the belt shifting off the center.
Tension Control Knob
Locking Knob
