ASSEMBLING HANDLEBAR AND COMPUTER
A) Use two bolts (42), two curved washers (47) and two nuts (49) to attach the handlebar (36) to the upper main
frame (51).
Please be sure that the hand pulse cord (41) is not crushed.
B) Remove both pre-mounted crews from the back of the computer (40) and use the two screws to attach the
computer (40) to the upper main frame (51).
C) Connect the cord from the back of the computer (40) to the upper sensor cord (53).
D) Insert the hand pulse cord (41) into the socket (PULSE) on the back of the computer (40).
INSERTING BATTERIES
A. Open the battery compartment on the back of the computer (40). Clean the battery contacts and the contacts
of the device prior to inserting batteries if necessary.
B. Insert two batteries 1.5V type AAA into the battery compartment. When inserting batteries, be sure to check
the correct polarity (+/-). The computer will signal with a long beep.
C. Close the battery compartment and make sure the cover snaps in place.
12
Summary of Contents for IN 9101
Page 1: ...USER MANUAL EN IN 9101 Power Stepper inSPORTline Bailar 1...
Page 4: ...EQUIPMENT 4...
Page 18: ...EXPLODED DRAWING 18...
