23
Step 2.
After loosening the screw, lift up the running belt and clean in-between the running board.
Squeeze the small white bottle of SILICONE oil which was supplied with your purchase and wipe it
evenly across the board.
Step 3.
After lubricating the board, screw the belt tension back to its correct tension. Tighten evenly
on both sides. When it is almost tensioned, run the treadmill at 1km without any load. Adjust both
tension screws to make the belt in the center of the back roller. Run the treadmill at 5km for 3mins.
Step 4.
Stop the treadmill and start to walk on it at 5km/h. Lastly fine tension both screw
s until it’s
running smoothly with your weight on.
CLEANING
a) Please power off and pull the plug out before cleaning.
b) Wipe out the dust stuck on the surface and running board frequently.
c) Please clean the surface of frame and running belt with a soft cloth
dipped with suds, don’t
use things like eradicator and naphtha. (After cleaning, please dry it for use)
d) Please take the protecting cover off every two months, use vacuum dust-collector to suck the
dust remaining inside of the protecting cover. (The dust will make the components of circuitry
board short circuit)
CAUTIONS, DEPOSITING
Cautions
Please make sure that the plug has been pulled out before cleaning or maintenance.
Depositing
The tr
eadmill should be deposited indoor in case of being damp. Water can’t be spattered, and
nothing can be laid and inserted on the treadmill.
Please keep the air a little humid in winter. And please void the big static electricity, it may disturb the
operation of meters or even damage them.
GUIDES FOR MALFUNCTION
Analyzing and eliminating malfunction
Item.
Malfunction
Reasons
Solution
1
Treadmill can’t be
started
The safe key isn’t in the
right position
Put the safe key in the right position
The electrical switch is
placed to “0”
Turn the electrical switch to “1”
2
Meter ca
n’t display
The meter and upper
communication line are
not connected well
Disassembly meter and check the upper
communication line, make sure that
meter and communication line are
connected well.
The upper
communication is broken
Replace it!
