10
A)
Connect the wire from the console to the wire in the right console mast.
B)
Assemble the console to the console masts with four M8x15mm bolts (57) and washers (56). (Do not
tighten the bolts)
ATTENTION: Be careful when you connect the two console–controller wires. There are pins inside connector,
the pins must be straight, otherwise it will cause problems.
STEP 4: Tighten Step 1, Step 2, Step 3 bolts
First open switch and working machine, then tighten bolts with the provided Allen key.
USAGE INSTRUCTIONS
TURNING ON THE MACHINE
Make sure that the treadmill is correctly connected to power source. Open on/off switch (1), turn it ON and it
will be light. You will hear a signal tone and the LED screen of the Computer will light up.
SAFETY KEY
The treadmill will only work if the safety key is properly locked in the provided notch of the computer. Inset the
safety and attach the clip onto waist part of your clothes. In case of trouble, where it is necessary to turn of the
motor immediately, simply push out the safety out of the console by pulling the rope. To turn the treadmill on
again, turn the main switch off and then put the safety key back into the notch on the console.
(Be sure to attach
the safety clip to your clothing when the treadmill is in use. Remove the safety key when it is not in use
and store away from children.)
FOLDING INSTRUCTIONS
The treadmill can be folded for space-saving storage
.
Folding:
To fold the treadmill, lift the plate up and lock.