16
Warning:
The treadmill must be turned off to avoid electrical shocks. The power cord must be pulled
out of the socket, before starting the cleaning or maintenance.
After each training:
Wipe the console and other surfaces with a clean soft and damp cloth to remove
sweat residues.
Caution:
Do not use any abrasives or solvents. To avoid damage to the computer, keep any liquids
away. Do not expose the computer to direct sunlight.
Weekly:
To make the cleaning easier it is recommended to use a mat for the treadmill. Shoes can leave
dirt on the striding belt that can fall beneath the treadmill. Clean the mat under the treadmill once a
week.
STORAGE
Store you treadmill in a clean and dry environment. Ensure the master power switch is off and is un-plugged
from the electrical wall outlet.
IMPORTANT NOTES
The device corresponds to current safety standards. The device is only suitable for home use. Any other
use is impermissible and possibly even dangerous. We cannot be held liable for damages that were
caused by improper usage.
Please consult your GP before starting your exercise session to clarify whether you are in suitable
physical health for exercising with this device. The doctor’s diagnosis should be the basis for the
structure of your exercise program. Incorrect or excessive training could be harmful to your health.
Carefully read through the following general fitness tips and the exercise instructions. If you have pain,
shortness of breath, feel unwell or have other physical complaints, break off the exercise immediately.
Consult a doctor immediately if you have prolonged pain.
This fitness device is not suitable for professional or medical use, nor may it be used for therapeutic
purposes.
The pulse sensor is not a medical device. It is meant for your information purposes only and is designed
to give an average pulse rate. It is not intended to offer medical advice nor will it measure pulse
accurately every time, due to differing environmental and human conditioning factors.
TROUBLESHOOTING
ERROR
CODE
CAUSE
SOLUTION
E0
Not equip Safety key
Please equip the Safety key.
E1
Speed feedback equipment err
1.
Please check Speed feedback equipment and 10-pin
cable or contact special service.
2.
Caused by overload of the user weight, 3 lights display
at the same time on the controller. Please switch off the
power, and restart in 30 seconds.
E2
Motor or Motor drive err
Please check PIN cable or contact special service.
E3
The error of Speed over limit
Adjust Speed feedback equipment or contact special
service.
This treadmill is designed to be reliable and easy to use. However, if you experience a problem, please reference
the trouble shooting guide listed below:
PROBLEM:
The console does not light up.
SOLUTION: Verify that the power cord is plugged in properly to the outlet, and the treadmill switch is turned
on.
