5
Safety Introduction
prevent damage to the components or scratching of the arms.
5)
Carefully deal with the components and plug-in cards, and please never
touch, the components or connection points on the plug-in cards. When
taking the plug-in cards or components, you should grab the edges of the
plug-in cards or components or their metal fixed supports.
8.
During the process of cabinet installation and application, please pay attention
to the following matters:
1)
After the installation of cabinet is finished, please ensure that the supporting
feet have been fixed to the rack and supported to the ground, and all weight
of the rack have been fell onto the ground.
2)
It shall install into the cabinet according to the sequences from the bottom to
the top, and first install the heaviest component.
3)
When pulling out the components from the cabinet, it shall apply force
slightly to ensure the cabinet to keep balance and stabilization.
4)
When pressing down the release latch of the sliding rail of components and
sliding in or out, please be careful, as the sliding rail may hurt your figures.
5)
Never make the AC power branch circuit in the cabinet overload. The sum
of cabinet load shall not exceed 80% of the ratings of branch circuits.
6)
Ensure that components in the cabinet have good ventilation.
7)
When repairing components in the cabinet, never step on any other
components.
