68
7.3 Firmware Update
For BIOS update, you could select to update in UEFI shell or OS .
7.3.1 Update BIOS in UEFI shell
1)
When Inspur Logo appears during sytem startup, there is a prompt “Press <DEL> to SETUP
or <F11> to Boot Menu or <F12> to PXE Boot” on the bottom of the screen. Press F11 to
start the Boot Menu, and enter EFI shell.
2)
Enter the disk in which the BIOS flash toolkit H2OFFT-Sx64.efi resides, enter the flash
toolkit folder, and BIOS.bin is the 32M BIOS+ME file to be updated. Execute the command
H20FFT-Sx64.efi XXXX.bin -ALL –SSB to flash BIOS+ME, and execute H20FFT-Sx64.efi XXXX.
bin -ALL -BIOS –SSB to flash BIOS only, as shown in the following figure.
Note:
After updating ME+BIOS, please power off the machine, confirm that there is no
residual electricity on the motherboard, and then power it on.
7.3.2 Update BIOS in Linux OS
There’re 32bit and 64bit Linux OS H2OFFT tools. Here take Linux 64bit OS as an example,
using H2OFFTx64.sh tool. Enter the directory containing H2OFFTx64.sh tool, meanwhile,
put the bin file of corresponding BIOS into this folder. Execute the command ./H2OFFTx64.
sh -ALL -SSB to flash BIOS+ME, and execute ./H2OFFTx64.sh -ALL -BIOS –SSB to flash BIOS
only, as shown in the following figure.
Summary of Contents for NF5288M5
