3
Safety Introduction
1)
The power cables, extension cables or power plugs are damaged.
2)
The products get wet.
3)
The products have fallen or have been damaged.
4)
Other objects have fallen into the products.
5)
The products do not or are unable to function normally even when attempting to
operate according to the instructions.
2.
If the system becomeswet or damp, please follow these steps:
1)
Power off the equipment, disconnect them with the power socket, wait for 10 to
20 seconds, and then open the host cover.
2)
Move the equipment to a well-ventilated place to dry the system at least for 24
hours and make sure that the system is fully dried.
3)
Close the host cover, reconnect the system to the power socket, and then power
on.
4)
In case of operation failure or other abnormal situations, please contact Inspur and
get technical support.
3.
Pay attention to the position of system cables and power cables-avoid placing wires in
high foot traffic locations. Please do not place objects on the cables.
4.
Before removing the host cover, and/or touching the internal components, please
allow for the equipment to cool first. To avoid damaging the mainboard, please power
off the system and wait for five seconds, and then remove the components from the
mainboard and/or disconnect the peripheral device from the system. Please remember
that only service technicians trained by Inspur are authorized to remove the cover of
the host, and to remove and replace internal components.
5.
If there is modem, telecom or LAN options installed in the equipment, please pay
attention to the followings:
1)
In the case of thunder and lightning, please do not connect or use the modem.
2)
Never connect or use the modem in a damp environment.
3)
Never insert the modem or telephone cables into the socket of network interface
controller (NIC).
4)
Before unpacking the product package, installing internal components, touching
uninsulated cables or jacks of the modem, please disconnect the modem cables.
6.
In order to prevent electrostatic discharge from damaging the electronic components in
the equipment, please pay attention to the followings:
Summary of Contents for NF8380M5
