Advanced Driver Assistance System (ADAS) and Backlight
1. Why does the screen keep turning on with still images while driving?
Answer:
This dash camera is equipped with a series of alerts to remind the
driver of specific events. If one of these criteria are triggered, an alert will flash
on the screen and will be accompanied by a beep. This on-screen image doesn't
affect recording – the dash camera will continue to record in the background.
ASAS does not necessarily indicate an Event.
1.
Lane-Departure-Warning-System (LDWS)
: If lane-changing or swerving
occurs, a [swerving car icon] warning will appear to notify the driver. This is
tied into the GPS module and cable that fits into the top of the camera, as well
as satellite map information. On occasion, this warning may be set off by
GPS signal inaccuracy or incomplete/inaccurate road data supplied by the
GPS satellites.
2.
Low-Light-Warning-System
: The camera will remind you to turn on
headlights in low-light conditions with a [headlights and exclamation mark in
triangle icon].
3.
Driver-Fatigue-Warning-System
: The dash camera will send a [napping
driver] warning picture and tone when continuous driving (more than 4 hours)
is detected. This will follow every two hours until the camera stops recording
or is turned off.
2. How do I turn the ADAS settings Off?
Answer:
Some drivers find the ADAS settings distracting, particularly while
driving long distances at night. By default, this setting is turned Off. If you find
that this setting has been turned On, you may want to adjust the Backlight (LCD)
Settings (found in Question 3 of the Advanced Driver Assistance (ADAS) and
Backlight section). You cannot turn on or off individual alerts; these are all On or
Off.
Troubleshoot:
1. Press the Menu/Back (bottom-left) button on the back of the camera. Doing
so will stop the camera recording and show the Menu (P 1/5).
2. Press the Up or Down arrows located to the right of the viewscreen to tab to
Menu (P 2/5) until “ADAS Detect” is highlighted.
3. Press the OK button (top-left button on the back of the camera) to Confirm
your selection.
amiGO! Dash Cam DC711 FAQ Version 1.2 (03/22/19)
Page 18
