Page 4 of 27 Rev: 4/19/2013 10:47 AM
INSTEON Wireless Thermostat Button Overview
1)
Up/Down
adjusts the temperature setpoint based on the current mode
2)
Mode
allows the user to select the current operational mode of the HVAC system. It cycles
between Off, Heat, Cool, Auto and Programmed Auto.
3)
Energy
button is a quick option that saves energy (and money). When pressed, it sets back the
setpoint by a specified value. The default value is 4° from the current setting. To change the
default offset value to be a value other than 4°, you must use software, such as HouseLinc.
4)
Hold
overrides a pre-programmed mode
5)
Fan
cycles between Auto and Always On
6)
Master
makes this device the master temperature controller. Pressing and holding “Master” does
not alter any scene or screen settings. It just defines this INSTEON Wireless Thermostat as the
master temperature controller.
7)
Time/Sensor
button allows you to set the date and time. It cycles between hour, minute and time
format.
8)
Program
button allows you to setup the various pre-programmed user modes
9)
Set
button adds and removes INSTEON Wireless Thermostat from scenes. It functions like the
Set button on other INSTEON devices.
2
4
5
6
7
8
9
3
INSTEON Wireless Thermostat
The gray buttons
are under the
INSTEON
Thermostat door
Cool setpoint
Heat setpoint
Programmed
auto state
Humidity level
Time
Current
temperature
Temperature(s) of external
sensor and/or wireless
thermostat
Current
thermostat
mode:
Off, Auto,
Heat or Cool
1
