Page 6 of 27 Rev: 4/19/2013 10:47 AM
•
If you set Heat and Cool to the same temperature setpoint, Heat will automatically move
down 2° (the minimum allowable gap).
Energy Button Operation
The Energy button (designated with the leaf) is a quick, efficient energy-saving option. When you press
the Energy button, INSTEON Wireless Thermostat will adjust the Heat and Cool setpoints by a specified
value. The default value is 4° from the current setting, but can be changed via home control software
such as HouseLinc.
•
When you exit Energy mode, it will revert back the 4° that was changed upon entry.
•
The unit remains in Energy mode until the Energy button is pressed again.
•
Up/Down arrows adjust the temperature setpoint based on the mode you are in.
From Off Mode:
•
Energy button does nothing because the
system is off (at maximum energy savings
already)
•
When “Energy” appears on the screen for
Auto, Cool and Heat Modes, the 4°
setback is engaged
From Heat Mode:
•
Heat setback as specified
•
Default setback is 4° less
•
Notice that “Heating” is active on the left,
but not on the right since the setpoint is
lower that the actual temperature; the
element reads “Heat”
From Cool Mode:
•
Cool setback as specified
•
Default setback is 4° more
From Auto Mode:
•
Both Heat and Cool setpoints changed as
specified
•
Default setback is 4° more for Cooling and
4° less for Heating
•
Notice that “Heating” is active on the left,
but not on the right since the setpoint is
lower that the actual temperature; the
element reads “Heat”
