background image

1

 

service@casualwayusa.com

If you have any questions or comments about this product, please contact us 

at

 

We recommend using minimum two people to assemble the gazebo.

Additional tools you will need include two ladders, work gloves and a spirit level. 

Do not destroy or discard boxes until the gazebo is fully assembled.

Do not fully tighten bolts until assembly is completed. Be careful to not over tighten 

bolts if using a power driver. 

Ensure you understand each step and get the required parts ready before beginning.

Assembly tips

 

Always read and follow the instructions before use. 

When assembling and using this product, basic safety precautions must always 

be followed to reduce risk of personal injury and damage to the product or 

surroundings. Be sure to keep all children and pets away from assembly area. 

Do not attempt to assemble the gazebo in windy condition. 

Do not place your gazebo in an area exposed to excessive wind. 

Some parts contain sharp edges. Wear protective gloves when handling these items. 

You must schedule enough time to complete the assembly. You can not leave the 

unit unattended if it is not fully assembled, even if it is already anchored to the 

ground. 

You should begin the assembly no less than 6 feet from any fixed obstruction such 

as fences, a garage, a house, overhanging branches, electrical wires or washing 

lines. 

You must assemble your gazebo on a level ground or platform.The unit must be 

anchored to either wood, stone tiles or concrete using appropriate screws for that 

flooring, or anchored into the earth or grass with proper camp nails or anchors.

Your gazebo has been designed to be a non-permanent structure. Do not use this 

gazebo in storms, cyclones or very strong winds.

The unit must always remain anchored properly to the floor or ground using the 

appropriate fixings to enjoy safe usage of the gazebo. 

KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This Tent 

is Made With Fabric That Meets CPAl-84 Specification For Flame Resistance. lt is Not 

Fire Proof. The Fabric Will Burn lf Left ln Continuous Contact With Any Flame Source. 

The application of any foreign substance to the tent fabric may render the flame-resistant 

properties ineffective.

Summary of Contents for 6414-287









Reviews: