3
Assembly
STEP 1. Setting up the top frame
1.1 Attach the two Beam C to the Beam joint D to have full length Beam as show in Fig.1.
Repeat this until all four beams assembled. Please note the short tube connector on Beam joint D
must face inside.
1.2 Attach the full length Beam to the Corner Connector A as show in Fig.2. Repeat this until all four
assembled.
1.3 Attach the Support Bar G to the Corner Connector A and Beam C with Gasket K/Bolt(M6*15) I/Bolt
cap Bolt P as show in Fig.3.
Note:do not tighten bolts until all parts are connected
Fig.1
Fig.2
Fig.3
