INSYS ISDN TA 4.0
Functions
9.3.2
Disabling an Automatic Call
If the function "automatic call" is enabled, the INSYS ISDN TA 4.0 does not accept
AT commands anymore. To be able to configure the INSYS ISDN TA 4.0 again, you
must disable the function.
To change the INSYS ISDN TA 4.0 to configuration mode with enabled function
"automatic call"
The function "automatic call" is active.
Your terminal program is connected to the INSYS ISDN TA 4.0.
The serial interface speed is configured to 9600 bps.
1.
Press the reset key at the INSYS ISDN TA 4.0.
2.
The terminal program displays the message
"+++ press <CR>, <CR>, <ESC>,<ESC> to enter TA+Configurator
+++".
This message does not appear if it is disabled by the command
AT**RSTMSG=0
.
3.
Quickly double-press the "Enter" key and the "ESC" key.
You are in the TA+Configurator and can configure the INSYS ISDN TA
4.0 with the dedicated TA+Configurator commands again.
4.
Enter
cmds=0
to disable the function "automatic call".
5.
Save the settings (if desired) with the command
save.
6.
Exit the remote configuration with the command
go
.
45
