Functions
INSYS ISDN TA 4.0
9.5
Remote Configuration
You can configure the INSYS ISDN TA 4.0 with another ISDN TA from remote. You
can configure a password, authorised callers as well as a remote configuration
number to restrict access. The configuration is performed via the TA+Configurator.
This is automatically started after the connection establishment for remote
configuration.
The remote configuration is active as default. No password is entered and all callers
are authorised.
9.5.1
Remotely Configuring the INSYS ISDN TA 4.0
The following describes the commands for the remote configuration of an
INSYS ISDN TA 4.0 using a second INSYS ISDN TA 4.0:
Your terminal program is connected to the local INSYS ISDN TA 4.0.
1.
Configure the B channel protocol X.75 at the local INSYS ISDN TA 4.0
using the command
ATB10.
2.
Establish an ISDN connection to the "Remote TA" using the AT
dialling command. Use the command
ATD<phonenumber>e.
The extension "e" at the end of the phone number establishes an
internal control connection to the remote TA
The "Remote TA" replies with a password request.
password:
3.
Enter the correct password.
If the INSYS ISDN TA 4.0 is configured to default settings: no
password, simply hit the Enter key.
Each line starts with a "#" character during remote configuration.
the TA+Config
Use
urator commands (refer to table TA+Configurator
commands).
o read out the settings for example, use the command
ure the INSYS ISDN TA 4.0, which is to be remotely configured,
now.
5.
Save the settings (if desired) with the command
6.
Exit the remote configuration with the command
In order t
showall
.
4.
Config
save.
go
.
48
