INSYS ISDN TA 4.0
Functions
9.7
Control Outputs
The INSYS ISDN TA 4.0 provides two control outputs OUT1 and OUT2 at the
bottom of the housing. The outputs are designed as potential-free change-over
relays. They can be controlled independently of each other via AT commands. The
outputs can also be switched via remote configuration. The control outputs remain
in a state until this is changed by a switch command.
The state of the control outputs can be queried in the status registers (S registers)
S14 (output 1) and S15 (output 2).
Both control outputs are not connected to GND in default setting.
Configuration with HSComm
The outputs can be opened or closed on the "Control outputs" tab in the
"Control output" panel (Figure 9, page 38, position 2 & 3).
Configuration with AT commands
To switch the outputs use the command
The following applies:
<Out>
is "0" for
output 1 and "1" for output 2 and
<state>
is "0" for off and "1" for on.
AT*Y<out>,<state>
In order to enable output 1, use the
command
AT*Y0,1
In order to disable output 2, use the
command
AT*Y1,0
53
