Page 13
Section 7
-
sequence of first power up menu.
06/21 E&OE
OK (set)
OK
ON /OFF
UP
and
DOWN
arrow buttons
On first power up, the controller will perform a check
on all connected components. If all is OK, it will
automatically proceed to the set up menu. If a fault or
wiring error is detected, a warning symbol will appear
until the error is corrected.
START HERE
The correct date and time is
required for recording a
history of diagnostic codes, or
timed functions (see page 15).
5b
SET TEMP RADIATOR
60 C
Factory setting for radiators
is 60C.
Press OK or change with the
up and down arrow buttons
to increase or decrease the
heating flow temperature.
Pres OK to set.
Next screen will be to set
the hot water temperature
SET DHW.
SET TEMP DHW
55
DHW
(domestic hot water)
temperature is factory set
to 55C. Press OK or change
with the up and down arrow
buttons to increase or
decrease the temperature.
Drying starts at the minimum temperature.
25°C as factory setting for 3 days then rises to the maximum
factory set temperature (40°C as factory set) for 4 days.
The function can be stopped by pressing the OFF button.
Controller screen looks like
this, now in standby mode.
The icon that can be seen
shows
‘
Keep Warm
’
function is ON.
SETRT=46.5 OK
This is a
‘
one off
’
start up sequence to ensure the selection of radiators or UFH .
SET HEATING
RADIATOR
Change to YES using the UP
or DOWN button to initiate
the floor drying for a new UFH
system.
SELECT FLOOR HEATING or
RADIATOR
UFH is the factory default.
Use the arrow UP/DOWN arrow
buttons to change to RADIATORS
7.
ENGLISH, ITALIANO,
FRANCAIS, NEDERLAND
or DEUTSCH.
Factory setting for UFH is 30°C.
Press OK or change with the
UP and DOWN arrow buttons
to increase or decrease the
heating flow temperature.
Press OK to set.
SET LANGUAGE
ENGLISH
2.
SET DATE
01/01/21
1.
3.
SLAB DRYING
STOP=167h 59m
TFLOOR = 24.5C
SET HEATING
FLOORHEATING
SLAB DRYING
NO
6.
5a.
SET TEMP FLOOR
30 C
4.
SET TIME
09.30
6a.
UP and DOWN
buttons
-
use to increase or decrease a
value or number.
OK
button
-
to confirm and set a value or number.
ON / OFF
button will turn off the HIU.
The unit will not be in standby mode.
Heating, hot water, keep warm and frost protection functions
are OFF.
Operation.
