Inta HTMDMCP, Installation And Maintenance Instructions Manual

© Intatec Ltd 2016

2

Introduction 

    This installation guide has been produced for the wall and deck mounted sequential control 
    mixer. These instructions cover the installation, operation and maintenance. Please read the 
    enclosed instructions before commencing the installation of this product, please note;

   We recommend that the installation is carried out by an approved 
   installer.

    The installation must be carried out strictly in accordance with the Water Supply (Water Fitting) 
       Regulations 1999 and any local authority regulations.
    If in doubt we recommend that you contact WRAS - Water Regulations Advisory Scheme on 
    Tel: 0333 207 9030, your local water authority - details available on the WRAS website or the 
    Chartered Institute of Plumbing and Heating Engineers on Tel: 01708 472 791.
    All products MUST be re-commissioned to suit site conditions to ensure optimum performance 
    levels of the product are obtained.

Check Content

    Before commencing remove all components from packaging and check each component with 
    the contents list. 
    Ensure all parts are present, before discarding any packaging. If any parts are missing, do not 
    attempt to install your control mixer until the missing parts have been obtained.

Product Range

    HTMWMCP - HTM safe touch thermostatic sequential wall mounted tap. 
    HTMDMCP -   HTM safe touch thermostatic sequential deck mounted tap.
    HTMWMRS -  HTM safe touch thermostatic sequential wall mounted tap with removable spout.
    HTMDMRS -   HTM safe touch thermostatic sequential deck mounted tap with removable spout.

Technical Data

    This Inta thermostatic mixer is suitable for installations on all types of plumbing systems, including 
    gravity supplies, fully pumped, modulating combination boiler, unvented water heater and 
    unbalanced supplies i.e. Cold Mains & Tank Fed Hot.
    Max Dynamic Pressure                       5 bar      Min Operating Pressure                 1.0 bar
    Max Static Pressure                            12 bar    Min Inlet Temperature                    10˚C
    Max Inlet Temperature                        85˚C      Temperature Stability                     ± 2˚C
    Pre Set Factory Temp Setting                41˚C      Min Temp Differential to                 
    Max Unbalanced Pressure Ratio                        ensure fail-safe between hot            

        Without Flow Regulator                   5:1         and cold supplies                          10˚C

Preparation for Installation

    Before starting the installation, ensure that the site conditions are suitable - see Technical Data.
    The tap is supplied for wall or deck mounting as shown.
    Flush the water supply pipes thoroughly prior to installation - see page 13. Do not allow debris, 
    PTFE tape or any metal particles to enter the mixer.