© Intatec Ltd 2012
6
ADDING WATER TREATMENT
To add water treatment chemicals via the IntaKlean, first ensure the system is
appropriately isolated then close the upper ball valve leaving the lower valve open.
Drain a suitable volume of water from a drain point at the lowest part of the central
heating system. Ensure a sufficient amount of water is drained to allow space for the
volume of chemicals required.
The IntaKlean has a large 500ml dosing capacity, which in most cases, should prove
sufficient.
When the IntaKlean is empty, using an appropriate tool, remove the air vent from the
top of the collection vessel.
Insert a funnel into the open aperture and dose the system accordingly.
Re-commission the system as per the previous instructions in the COMMISSIONING
section.
