© Intatec Ltd. 2006
3
Connect the other wire from the electronic unit to the power supply, either battery or transformer.
Turn on the water supply and make a final check to ensure there is no water leakage.
Assemble the cover plate to the cover seat and secure with the screw located at the bottom of the cover
plate.
If your model is the IR231CP, plug the transformer into the electricity supply.
Move away to activate the flush valve. The valve will flush water a few seconds after your departure.
If needed adjust the flow capacity by turning the regulating valve.
If the sensor range is unsatisfactory, refer to the section entitled “Range Adjustment”
A
Ad
djjuussttiinng
g tthhee sseennsso
orr rra
anng
gee w
wiitthho
ouutt a
a rreem
mo
ottee cco
onnttrro
oll
((A
Ad
djjuusstt o
onnllyy iiff nneecceessssa
arryy))
The sensor range is the greatest distance, an object can be from the sensor, to activate the flush valve.
The factory setting should be satisfactory for most installations. If the range is too short (i.e. not sensing
users) or too long (i.e. sensing the opposite wall), it may be adjusted as follows:
Disconnect the battery or switch off the electricity supply
to the sensor.
For the IR230CP make a short circuit between the (+)
and the (-) connections of the sensor for 5 seconds. A
screw driver can be used or any conductive material to
make this short circuit.
For the IR231CP after disconnecting the power supply,
activate the sensor three or four times.
D
Do
o nno
ott m
ma
akkee a
a sshho
orrtt cciirrccuuiitt o
onn tthhee p
po
ow
weerr ssuup
pp
pllyy o
orr o
onn tthhee sseennsso
orr w
whheenn tthhee p
po
ow
weerr ssuup
pp
pllyy iiss
cco
onnnneecctteed
d tto
o tthhee sseennsso
orr..
Re-connect the power supply to the sensor.
To enter into the adjusting mode, put your hand in front of the sensor at a distance of 5cm (2”) to
10cm (4”) within 5 seconds of re-connecting the power supply.
N
No
ottee:: If you do not put your hand infront of the sensor after re-connecting the power supply, the sensor
will not enter adjusting mode and the previous adjustment will return.
For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - info@mytub.co.uk
