Inta IT1007CP, Nstallation And Maintenance Instructions

© Intatec Ltd 2021

10

Commissioning

   2   Commissioning the temperatures must be carried out using a suitably calibrated 

        thermometer preferably a digital thermometer. 

   3   In the absence of other temperatures being specified, we recommend the outlet temperature 

        quoted in Table 1 are used. 

Table 1

   4   Each basin tap must be commissioned taking into consideration any fluctuations, which 

        may occur within the system due to simultaneous demands. It is advisable that any outlets 
        which are connected to the same supply as the basin tap are opened during the setting of 
        the mixed water temperature. During commissioning it is advisable to ensure that the water 
        temperatures are established before any attempt to commission. 

   5   Once the supply temperatures are stable and the normal operating conditions are 

        established, the tap can be commissioned. The temperature setting can be adjusted 
        following the procedure described earlier in the Temperature Setting section.  

        We suggest that the following sequence is followed when commissioning the valve: 

        5.1 Set the mixed water temperature to the required temperature. 

        5.2 Measure and record the temperature of the hot and cold water supplies at the 
        

connection to the tap. 

        5.3  Measure and record the temperature of the water discharging from the basin tap. 

        5.4  Isolate the cold water supply to the tap and monitor the mixed water temperature. 

        5.5 Measure and record the maximum mixed water temperature and the final temperature. 
        

The final temperature found during the test should not exceed the value quoted in    

Table 2. 

        5.6  Record all the equipment used during the commissioning.

Table 2

Application

Maximum Set Mixed Water Temp.

Wash Hand Basin

43˚C

6  Ensure that the application, in which the basin tap will be used, is appropriate for the 

   approved designation. The above information must be recorded and updated on every 
   occasion when any work is carried out on the basin tap.

Application

Recommended Set Mixed Water Temp.

Wash Hand Basin

41˚C