Inta Kiko DELUXE KIKOD20, Installation And Maintenance Instructions Manual

© Intatec Ltd 2017

19

Slide Rail - Installation

   The screws and wall plugs supplied are only suitable for use in solid walls. If the wall is plaster 
   board or soft building block use special wall  plugs obtainable from most DIY stores.

   Ensure there are no supply pipes or cables where you intend to drill. Take care to use power tools
   safely.

   Where possible, drill holes between ceramic tiles (in the grout). If drilling into ceramic tiles use 
   a ceramic bit. 

   This product must always be used and fitted in such a way as not to cause water damage, 
   therefore should be located and directed towards a suitable shower tray.

  •   Carefully remove the cover (3) from each wall bracket (1) and (2) to expose the fixing hole.

  •   Drill the 6 mm diameter hole for the bottom wall bracket (1).

  •   To avoid cracking ensure the wall plug is pushed all the way behind the ceramic tile.

  •   Using the 35 mm long screw (6) provided secure the wall bracket (1) to the wall.

  •   Slide the top wall bracket (2) with the wall plate (7) located onto the riser rail (9) and 

      position in the bottom wall bracket (1). 

  •   Position the upper bracket onto the wall ensuring the rail is vertical.

  •   Mark round the wall plate (7) onto the wall with a removeable marker.

  •   Position the wall plate (7) onto the wall within the markings and using the hole as a 

      template, drill a 6 mm diameter hole.

  •   Assemble the handset holder (5) and the flexible tidy (4) onto the riser rail as illustrated.

  •   Remove the bottom wall bracket (1) from the wall.

  •   Locate the top wall bracket (2) onto the wall plate (7) and using the screw provided secure 

      both item to the wall.

  •   Slide the riser rail (9) with the handset holder (5) and flexible tidy (4) upwards through the 

      hole in the upper wall bracket (2).

  •   Position the bottom wall bracket (1) onto the riser rail ensuring that the larger hole at the 

      bottom of the riser rail faces forward.

  •   Pass the screw provided through the riser rail and the bottom wall bracket and secure to the 

      wall.

  •   Fit the covers (3) to the wall brackets and fit the cap (8) into the top of the riser rail.

  •   Ensure the sealing washers (11) are inserted into both ends of the flexible hose (12) and 

      connect the hose to the shower valve and the handset (10).

  •   Turn on the shower valve and check joints for leakage.