© Intatec Ltd 2017
2
Introduction
This installation guide has been produced for the Kiko concealed dual outlet shower mixing
valve. These instructions cover the installation, operation and maintenance. Please read the
enclosed instructions before commencing the installation of this product, please note;
We recommend that the installation of any Inta product is carried out
by an approved installer.
The installation must be carried out strictly in accordance with the Water Supply (Water Fitting)
Regulations 1999 and any local authority regulations.
If in doubt we recommend that you contact WRAS - Water Regulations Advisory Scheme on
Tel: 0333 207 9030, your local water authority - details available on the WRAS website or
the Chartered Institute of Plumbing and Heating Engineers on Tel: 01708 472 791.
All products MUST be re-commissioned to suit site conditions to ensure optimum performance
levels of the product are obtained
Safety
This thermostatic shower must be installed and commissioned correctly to ensure that water is
supplied at a safe temperature to suit the users.
The shower is pre-set using ideal conditions to 38°C at the stop with a manual push button
override to 46°C (can be re-set to suit site conditions or user preference – see calibration
page 13).
The maximum mixed temperature takes account of the allowable tolerances inherent in
thermostatic shower mixers and temperature losses.
It is not a safe bathing temperature for adults or children
.
The British Burns Association recommends 37 to 37.5˚C as a comfortable bathing
temperature for children. In premises covered by the Care Standard Act 2000, the maximum
mixed water outlet temperature is 43˚C.
Technical Data
This Inta Kiko thermostatic shower valve is suitable for installations on all types of plumbing
systems, including gravity supplies, fully pumped, modulating combination boiler, unvented
water heater and unbalanced supplies i.e. Cold Mains & Tank Fed Hot. They are not suitable
for non-modulating combination boilers.
Max Inlet Pressure (Static) 12 bar Max Inlet Temperature 85˚C
Max Inlet Pressure (Dynamic) 5 bar Pre Set Factory Temp Setting 38˚C
Min Operating Pressure (Dynamic) 0.4 bar Temperature Stability ±2˚C
Max Unbalanced Pressure Ratio 5:1 Min Temp Differential to
Inlet Connections (Body only) G½” ensure fail-safe between hot
Outlet Connections G½” and cold supplies 10˚C
Summary of Contents for Kiko DELUXE KIKOD20
Page 27: ...Intatec Ltd 2017 26 Notes...
Page 28: ...Intatec Ltd 2017 27 Notes...
Page 29: ...Intatec Ltd 2017 28 Notes...
