© Intatec Ltd 2017
16
Water Outlets - Installation
• The pipework for the water outlets must be fixed securely to a structural members of the stud
wall and/or an additional member may need to be included.
• If there is access from the adjacent room into the wall cavity or from the room above or roof
space into the ceiling space, the surface of the shower room wall can be finished with most
of the tiling completed or the ceiling finished.
• Drill a hole in the required location for the wall elbow, overhead or ceiling soaker.
• A flanged elbow with a compression and female threaded connection may be used to
provide a secure connection for the outlets. Other types of fittings can be used which fit to a
structural member and provide the required connections.
• For the ceiling arm the fitting used should not protrude beyond the surface of the ceiling.
• Other fittings may be required to make the connection between the fitting fixed to the
structural member and the water outlet.
• Apply mastic to the inner edge of the wall elbow before fitting.
• Push the concealing plate of the overhead arm or ceiling arm to the wall or ceiling.
• Connect the water outlet to the mixed water supply from the shower valve.
• Turn on the water supplies and test all joints for leakage before finishing the wall. Any
leaking joints must be rectified before proceeding further.
Rinse Station
• Connect the handset to the hose using the sealing washer provided.
• Connect the hose to the outlet elbow using the sealing washer provided.
• Turn on the shower and check joints for leakage.
Slide Rail Kit
• Install the slide rail kit following the instructions given on page 20.
• Connect the hose to the outlet elbow using the sealing washer provided.
• Turn on the shower and check joints for leakage.
