© Intatec Ltd 2013
19
Installing the Riser Rail
The screws and wall plugs supplied are only suitable for use in solid walls. If the wall is plaster
board or soft building block use special wall plugs obtainable from most DIY stores.
Ensure there are no supply pipes or cables where you intend to drill.
Where possible, drill holes between ceramic tiles (in the grout). If drilling into ceramic tiles use
a ceramic bit.
This product must always be used and fitted in such a way as not to cause water damage,
therefore should be located and directed towards a suitable bath or shower tray.
Take care to use power tools safely.
To avoid cracking ensure the wall plugs are pushed all the way behind the ceramic tiles.
Assemble the handset holder onto the riser rail as shown.
Drill the two 6mm diameter holes for the lower wall bracket clip (2).
Fix the lower wall bracket clip to the wall using the 45mm long screws provided.
Position the upper wall bracket clip onto the wall and mark the position for the 2 retaining
screws ensuring that it is vertically above the lower clip and the centre distance does not
exceed 630mm.
Wall Bracket - Components
Upper Bracket Components
Lower Bracket Components
2
3
4
5
9
