Intec ColorCut BC480, User Manual

Page 36

Page 37

2-5-4 System settings

Under normal circumstances the BC480 will have been set up prior to shipping and you will not have 
to make any changes under the system settings.
Should you wish to only change an individual card setting please do this under the CARD OPTION 
menu specific to the card mode selected.

!

Attention:

Any changes made under the system settings will change the values for all preset card modes. 
These are universal changes.

The options available under the system settings are:

• 

System speed

• 

System accuracy compensation

• 

Five column blade (longitudinal) width - for 5 card cutting cassettes

• 

Three column blade (longitudinal) width - for 3 card cutting cassettes

• 

First cutting compensation

• 

Mark position compensation

• 

Groove width compensation

• 

Last card compensation

• 

Penultimate card compensation

• 

Third from last card compensation

• 

Subtotal clear

• 

Restore factory settings

• 

Firmware version

From standby mode, press 

MODE

SET

 and hold the button for 3 seconds to enter the setup menu, the 

LCD will display:

To navigate around the menus press the 

 or 

 buttons to move the cursor to system 

selection. Once you have selected the System option menu press the 

MODE

SET

 button which will take 

you to the sub menus.

To navigate around the following sub menus use the 

 button.

i

To easily make changes to a measurement values and when in the menu you would like to 

change, press the 

START

STOP

 and this will add a small arrow above the measurement values as shown 

below. Keep pressing until the arrow falls above the measurement you want to change and use the  

 or 

 buttons to change the value until you are finished.

1. System speed

This menu sets the speed of cutting of your sheets.

Changing the system speed can affect the cutting accuracy and positioning of your cuts.
The selectable options are 1-9 . 1 being the slowest and 9 the fastest setting.

As an example and using an SRA3 sheet for 85mm x 54mm cards (21 cards to cut) the system on 
setting 1 will take 9 seconds to cut the sheet and on 9 it takes 7 seconds to cut the sheet.

The BC480 will have been programmed and tested prior to shipping and so the value set in this 
menu should not be changed. However, if it has to be changed, we advise you do not set this to 
more than 8.

If you need to change the speed setting this can be done by using the  

 or 

 buttons.

2. System accuracy compensation

This refers to the scaling
This is set prior to shipping and should not be adjusted.